Children's Health | HVAC System Troubleshooting 101

Assessment Summary

0 of 8 Questions completed

Questions:

You have already completed this assessment. You cannot start it again.

Assessment is loading…

You must sign in or sign up to take this assessment.

You must first complete the following:

Results

Assessment complete. Results are being recorded.

Results

0 of 8 Questions answered correctly

Your Time:

You have reached 0 of 0 point(s), (0)

Current
Review
Answered
Correct
Incorrect

Question 1 of 8

1. Question
What is the purpose of a freeze stat installed on an air handling unit (AHU)?
- to prevent the unit coils from freezing
- to monitor chilled water temperature
- to provide a backup to the high static pressure sensor if it fails
- to monitor supply air temperature
Correct

Incorrect
Question 2 of 8

2. Question
A damper fails open on an patient room variable air volume (VAV) terminal unit. Which of the following areas or equipment are affected in this scenario?
- the patient room
- a downstream soiled utility room losing negative air pressure
- the air handling unit, supplying air to the patient tower, which requires a shutdown for inspection and repair
- the hot water reheat heat exchanger, which has likely failed
Correct

Incorrect
Question 3 of 8

3. Question
During routine rounds, a soiled utility room is found to have a positive air pressure relationship to the adjacent corridor. Which of the following steps should be the first course of action in this scenario?
- Check for proper exhaust fan operation (power, belts, etc.)
- Check the building automation system (BAS) for possible controls errors
- Install a portable HEPA fan
- Adjust supply air damper to reduce incoming air to the soiled utility room
Correct

Incorrect
Question 4 of 8

4. Question
A patient room thermostat displays a temperature of 65 deg. F, but the room feels hot. Which of the following steps should be the first course of action in this scenario?
- Check the thermostat for proper operation and calibrate or replace it as needed
- Decrease the air handling unit supply air temperature.
- Decrease the chilled water supply temperature.
- Override the airflow setpoint to satisfy the temperature requirement
Correct

Incorrect
Question 5 of 8

5. Question
If the hot/cold call is in an older part of the building, what may be the cause?
- Pneumatic valves
- Patients are hot after surgery
- Likely a facility-wide issue
- Surgeon’s are requesting to change the temperature for a surgery case
Correct

Incorrect
Question 6 of 8

6. Question
When responding to a hot/cold call, what should you do next if checking the thermostat did not resolve the issue?
- Measure the temperature from the diffuser.
- Review the Building Automation System (BAS)
- Call in a HVAC contractor
- Ensure the hot or cold water valves are responding
Correct

Incorrect
Question 7 of 8

7. Question
What does an “unreliable” alarm status in the building automation system (BAS) indicate?
- Loss of communication
- The alarm is offline
- The alarm is out of range
- A VAV terminal unit needs to be reset
Correct

Incorrect
Question 8 of 8

8. Question
If you were needing to the correct number of air changes for a clean utility room, what would you reference?
- American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE) Standard 170, Table 7.1
- National Fire Protection Association (NFPA) 99
- National Fire Protection Association (NFPA) 101
- The Joint Commission Standards
Correct

Incorrect

Children’s Health | HVAC System Troubleshooting 101

Children’s Health | HVAC System Troubleshooting 101

Children’s Health | HVAC System Troubleshooting 101

Assessment Summary

Information

Results

Results

Categories

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question