Children's Health | Medical Gas and Vacuum System Troubleshooting 201

Assessment Summary

0 of 8 Questions completed

Questions:

You have already completed the assessment before. Hence you can not start it again.

Assessment is loading…

You must sign in or sign up to start the assessment.

You must first complete the following:

Results

Assessment complete. Results are being recorded.

Results

0 of 8 Questions answered correctly

Your time:

You have reached 0 of 0 point(s), (0)

Current
Review
Answered
Correct
Incorrect

Question 1 of 8

1. Question
What is the correct pressure range for medical gas alarms?
- plus or minus 20% of the optimal pressure for each gas or vacuum
- plus or minus 10% of the optimal pressure for each gas or vacuum
- plus or minus 10% of the minimum pressure for each gas or vacuum
- plus or minus 20% of the median system pressure
Correct

Incorrect
Question 2 of 8

2. Question
According to code, what is the minimum number of panels required for master alarm medical gas or medical vacuum?
- 2
- 1
- 3
- 4
Correct

Incorrect
Question 3 of 8

3. Question
Which of the following outlet colors identifies an oxygen outlet?
- green
- white
- yellow
- blue
Correct

Incorrect
Question 4 of 8

4. Question
An oxygen outlet is continuously blowing out oxygen even though nothing is connected to it. Which of the following steps should be the first course of action in this scenario?
- Replace the "O" ring or oxygen outlet.
- Check the alarm panel for active alarms.
- Request nursing staff to plug in a flow meter to prevent the outlet from blowing.
- Shut off the zone valve.
Correct

Incorrect
Question 5 of 8

5. Question
A medical gas outlet is leaking in a patient room. Which of the following procedures should be followed as the first course of action in this scenario?
- Access the leaking outlet and determine if it is stuck open. If not, then retrieve a rebuild kit from the storage room and rebuild the outlet.
- Shut down the associated gas at the medical gas zone valve box. Then, relocate the patient until the leak is resolved.
- Create an emergency work order for a full service inspection by the outlet manufacturer or an authorized third party service provider.
- Remove the leaking outlet and replace it with a new one. Create a work order to rebuild the removed, leaking outlet.
Correct

Incorrect
Question 6 of 8

6. Question
What is the purpose of WAGD?
- to remove excess anesthetic gases from the anesthesia circuit
- to remove excess O2 from the oxygen circuit of the medical gas system
- to supply natural ventilation to an oxygen rich environment
- to provide ventilation in manifold/tank rooms
Correct

Incorrect
Question 7 of 8

7. Question
Which of the following devices serves as backup equipment during a loss of medical air supply to a facility?
- backup medical air compressor
- backup medical vacuum pump
- backup pneumatic air compressor
- nitrous oxide replacement tanks
Correct

Incorrect
Question 8 of 8

8. Question
Which of the following steps is the initial course of action if a high dewpoint alarm occurs on the medical air system?
- Switch out the dryers.
- Switch over to the backup compressor.
- Use H-cylinders until a service contractor resolves the issue.
- Shut down the system until the dewpoint returns to its normal parameter.
Correct

Incorrect

Children’s Health | Medical Gas and Vacuum System Troubleshooting 201

Children’s Health | Medical Gas and Vacuum System Troubleshooting 201

Children’s Health | Medical Gas and Vacuum System Troubleshooting 201

Assessment Summary

Information

Results

Results

Categories

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question