Children's Health | Plumbing System Operations 201

Assessment Summary

0 of 8 Questions completed

Questions:

You have already completed the assessment before. Hence you can not start it again.

Assessment is loading…

You must sign in or sign up to start the assessment.

You must first complete the following:

Results

Assessment complete. Results are being recorded.

Results

0 of 8 Questions answered correctly

Your time:

You have reached 0 of 0 point(s), (0)

Current
Review
Answered
Correct
Incorrect

Question 1 of 8

1. Question
Which of the following terms is best defined as the stationary portion of the valve that stops flow completely, when in contact with the movable portion?
- Valve seat
- Valve case
- Valve plug
- Valve port
Correct

Incorrect
Question 2 of 8

2. Question
Which of the following phrases best describes the function of expansion tanks in hydronic heating systems?
- Limits the increase in system pressure
- Limits the decrease in system pressure
- Limits the increase in system temperature
- Limits the decrease in system temperature
Correct

Incorrect
Question 3 of 8

3. Question
Which of the following phrases best describes how an expansion tank operates?
- Uses the pressure of air to control the pressure of an increased volume of water
- Uses compressed air to control the pressure of a decreased volume of water
- Prevents stored water from getting too cold or too hot
- Stores water in a single location so that it can be used in the system
Correct

Incorrect
Question 4 of 8

4. Question
What pipe material can be used for laboratory waste and vent applications?
- acid-resistant
- cast iron
- copper
- galvanized steel
Correct

Incorrect
Question 5 of 8

5. Question
What is the typical steam pressure for a domestic hot water heater?
- low pressure steam: 5 to 20 PSI
- high pressure steam: 60+ PSI
- medium pressure steam: 20 to 60 PSI
- extra-low pressure steam: less than 5 PSI
Correct

Incorrect
Question 6 of 8

6. Question
What is the protocol for turning the domestic hot or cold water over for domestic use after it has been down for 2 or more weeks?
- Flush water out from the system until the desired chlorine levels are achieved.
- Flush water out from the system until the water runs clear and tepid – minimum 3 minutes.
- Shock the domestic water system with additional chemical treatment for a minimum of 24 hours.
- Test the water for Legionella and treat accordingly.
Correct

Incorrect
Question 7 of 8

7. Question
Where should an isolation valve be installed in relation to the dielectric union when connecting two different piping materials?
- Immediately upstream of the union on the supply line
- Anywhere between the union and downstream of the equipment
- Immediately downstream of the union on the supply line
- Immediately upstream of the union on the return line
Correct

Incorrect
Question 8 of 8

8. Question
What type of backflow protection is typically used for a standard sink faucet?
- 2” minimum air gap between the space where the water comes from the faucet and the flood rim of the fixture
- backflow preventer
- check valve
- Backflow protection is not required on standard sink connections.
Correct

Incorrect

Children’s Health | Plumbing System Operations 201

Children’s Health | Plumbing System Operations 201

Children’s Health | Plumbing System Operations 201

Assessment Summary

Information

Results

Results

Categories

1. Question

2. Question

3. Question

4. Question

5. Question

6. Question

7. Question

8. Question