0 of 47 Questions completed
Questions:
You have already completed the assessment before. Hence you can not start it again.
Assessment is loading…
You must sign in or sign up to start the assessment.
You must first complete the following:
0 of 47 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
On a 2-way switch, what happens when the switch is in the up position?
If a surveyor asks you if you inspect the generator, what is the best response?
What type of confined space is a pit with wet concrete?
Which type of confined space entry is defined as a well-planned entry with a thorough review of the hazards in the space?
When testing for atmospheric hazards in a confined space, which of the following should be tested for last?
Rotating employees that are working inside of the confined space is known as what type of control?
What is a typical timeframe for Facilities Condition Assessments (FCA)?
What are CMS’ surveyor protocols known as?
Which accrediting organization requires a process based on ISO-9001?
Inspecting the emergency power system is one of many CoPs that hospitals must comply with in order to receive funding. Which AO is NOT likely to ask for this inspection documentation?
Why is it important to measure the conductivity of water?
What is the risk of failed open steam traps?
How is chiller efficiency measured?
What chiller approach temperature could be an indicator that the chiller tubes are fouled?
What is performed to determine the maximum number of cycles of concentration in a cooling tower?
Second to fuel, what makes up the largest portion of boiler operating costs?
What kind of water do boiler tubes require?
Why is steam that is too wet an infection control risk?
What happens if boiler water is not treated and the steam becomes too acidic?
When should chiller efficiency be evaluated?
What is the primary issue of closed loop systems?
Integrated system testing requirements are prescribed in which NFPA standard?
Duct detectors must be tested at their initial installation and how often after that?
What is not one of the 3 primary circuit types?
Patient care areas with water damaged must be checked for mold spores and other growth if the water damage exists for how many hours?
Which of the following circumstances is not a consequence of contamination?
When donning PPE, what is the first step in the process?
When doffing PPE, what is the final step in the process?
Which of the following is not a type of distribution system configuration?
Static pressure is a part of what type of law?
Direct steam and electric are two types of what device?
What do chillers use to remove heat from the building?
What cooling tower component slows down the water flow entering the system?
What percentage of the total condenser waterflow must be replaced with makeup water?
At what temperature does the purge pump start to remove air from the chiller?
What chiller component drops the pressure of the refrigerant and returns it to a liquid state?
What is known as raw water that has been treated?
What rating is the minimum fire-resistive requirement for a healthcare facility?
Corridor walls are only allowed in smoke compartments that have what installed?
What non-rated building component is constructed to limit the transfer of smoke?
What standard provides very specific requirements for piping and valve labeling?
MRI machine rooms are sectioned into safety zones and labeled with safety signage because their powerful magnets can cause personal injury past which zone?
Firestopping caulk must be what color?
How do you verify the status of an air compressor during the LOTO process?
To add additional scope to the project, what needs to be done ensure the project stays on track?
What is the title of the project process that outlines which entity does what and when and determines how much it will cost?
Where should the current PCRA document be kept?
Test Test
